Form
No.
1540-69
r9/29/17 ©
2017
Bobrick
Washroom
Equipment,
Inc. Printed
in
U.S.A.
Page 2
PRE-INSTALLATION.
A. Structural support in walls and fl oors is not furnished
by Bobrick. Confi rm that adequate backing is present
in wall, ceiling and fl oors prior to installation.
B. This installation booklet must be used with the Bobrick
layout sheets.
C. You may verify hardware receipt by cross-referencing
the last page of the layout sheets against the box
contents.
INSTALLATION STEPS.
1. Lay Out All Anchor Locations ............................ Page 3
2. Install All Anchors ............................................. Page 4
3. Install Wall Brackets .......................................... Page 7
4. Position Panels .................................................. Page 9
5. Install Stile-To-Panel Brackets ........................... Page 9
6. Install Stiles/Wall Post ..................................... Page 11
7. Install Headrail (if applicable) .......................... Page 12
8. Install Inswing Doors ....................................... Page 13
9. Install Outswing Doors .................................... Page 14
10. Install Shoes ................................................... Page 15
11. Finishing And Cleanup .................................... Page 16
A. .63 option uses steel core
reinforced stiles.
B. .64 option uses stainless
steel hardware.
C. .63/.64 option uses steel
core reinforced stiles and
stainless steel hardware.
D. Organize components with
appropriate hardware.
E. When calculating distances
to centerlines, all panels,
stiles, and doors are 1"
(25mm) thick.
F. Look for panel-to-stile
offsets indicated on the
layout sheets.
PREPARATION
RECOMMENDED TOOLS.
CAUTION: Be sure to use proper safety gear.
1.
Chalk Line
2. Plumb-bob
3.
Masking Tape (for laying out holes on
fl oors/walls/ceilings to be drilled)
4.
Tape Measure and Pencils
5.
Center Punch
6.
Electric and/or
Battery-Powered Drill
7.
Drill Bits
#19 (.166") M4.2
3/16" (4.7mm)
5/16" (8mm)
3/8" (9.5mm) for Concrete/Masonry
7/16" (11mm)
8.
Screwdrivers/Screwdriver Bits
slotted and phillips, #1, #2 and #3
9.
Pin-Head Torx Screw Driver – (to
install door hardware) – Supplied
by Bobrick
10.
Shims
11.
Adjustable Supports
1-1/2" to 12" (40–105mm)
12.
Level
13.
Wrench – 9/16" (14mm) open
end (2 reqd. for adjusting hex
nuts on anchors)
14.
Hack Saw
15.
Hammer
16
Safety Glasses
