![background image](http://html1.mh-extra.com/html/seima/liara/liara_installation-manual_1236015001.webp)
Large end of pan connector can
be trimmed to suit setout.
Threaded
section can
be trimmed to
required size.
IMPORTANT
1
Inspect the components before installation to ensure there are no visible defects.
If a defect is found, do not install the toilet suite and contact the supplier
immediately. Claims for defects will not be accepted after the product has been
installed.
2
This toilet suite is suitable for a variety of set-ups:
Cistern — accommodates either Back Entry Inlet connection or Bottom Entry Inlet
connection (left or right stop valve).
Pan — universal trap — accommodates S-trap installation or P-trap installation
(using appropriate connector; not supplied).
3
The toilet suite must be installed by a licensed plumber. Failure to do so may void
the warranty.
4
Installation must be in accordance with AS/NZS3500.
CISTERN PACKAGE CONTENTS
1 x ceramic cistern lid
1 x ceramic cistern base
Cistern is supplied with flush
valve and dual purpose inlet
valve already installed.
PAN PACKAGE CONTENTS
1 x ceramic pan
1 x pan connector
For connecting pan to floor
outlet pipe/S-trap.
1 x threaded section (with
flange plate)
Flange attaches to wall;
threaded section links to
pan connector.
2 x concealed fixing
brackets
Optional — can be
used to connect pan
to floor.
2 x floor bolts
(+ white plugs)
2 x washers
Optional fixing #2 — used
with fixing brackets to
secure pan to floor. Bolt is
inserted through bracket
base hole.
2 x caps (chrome plated)
2 x screws
2 x pan plugs (white)
Optional fixing #2 — used to
secure pan to concealed fixing
bracket. Plastic plug is placed
into hole in side of pan exterior,
screw is rebated into plug and
then screws into a hole in upright
section of bracket. Chrome cap
is used to cover plastic plug.
2 x bolts w seals
For attaching cistern to
pan. White component
at top enables hand
tightening.
2 x plugs
Plugs can be used to plug
holes in sides of pan if
required.
1 x rubber seal
For sealing outlet at
base of cistern.
1 x flush button
Half flush left, full flush
right.
Note:
The cistern can
be adapted for bottom
entry plumbing. The
bottom entry inlet
valve shown above is
included.
bot
tom en
try
inle
t v
alv
e
liara-wf-in | v 200 | page 1 of 4
INSTALLATION GUIDE
LIARA WALL FACED
s e i m a . c o m . a u
Please note
−
Installation shall be in accordance with AS/NZS3500.
−
All measurements are in millimetres. Height dimensions are to base of pan. Make allowance for bedding.
−
Bedding: Fix pan to floor using a sand cement mixture of 3:1 to a depth of 60mm. Do not use lime or fast-drying cement.
−
Bracket fixing: The pan should be bedded with an acetic cured silicone sealant and fixed with the brackets supplied.
−
Dimensions are nominal and subject to normal ceramic manufacturing variations.
−
Specifications may vary without notice as part of our continuous improvement practices.
−
Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.