5
FR
DE
EN
IT
Battery Warnings and Guidelines
Always use a
charger compatible
with batteries.
Always charge
Batteries away from
flammable materials.
Never Alter
Batteries.
Never charge
damaged Batteries.
Never touch or
use hot Batteries.
120F/49C
Never leave
charging Batteries
unattended.
Battery Charging
Celectra 1-Cell 3.7V Variable Rate DC Li-Po Charger Instructions
1. Connect power supply to an appropriate power source.
2. Insert output plug from power supply into the power input
slot of the Variable Rate Charger.
3. Select the appropriate charge current for your battery by
pushing the + or - which are the smaller buttons to the
right and left of the middle button. (When charging your
500mAh battery, set the charger to 0.7 amps)
4. Properly connect battery to the Charger lead. Match the red
dots on both the battery and charger connectors.
5. Press and release the start button on the Variable rate
charger (the largest button in the middle).
LED functions under normal operation:
SINGLE SOLID LED – Shows Charge Current
•
SINGLE LED FLASHING – Charging
•
MULTIPLE LEDs FLASHING – Charge Almost Complete
•
LEDs SWEEPING SIDE TO SIDE – Charge Complete
•
Note: We recommend to keep the charge rate at or below 2C. (Maximum charge rate 1.0 amp)
It is important that you only charge E-flite and ParkZone
®
1-Cell 3.7V Li-Po Batteries, used in our ultra micro flyers,
with the Celectra 1-Cell 3.7V Variable Rate DC Li-Po Charger.
Use the included E-flite 6V, 1.5-Amp AC/DC Power Supply (EFLC1005).
•
NEVER attempt to power the charger from an AC outlet without the use of a proper AC to DC
adapter/power supply.
DO NOT connect charged or discharged Li-Po batteries if the power supply is connected to the charger
while power supply is not connected to a power source. Doing so will discharge and possibly damage the
batteries.
Installing the Transmitter Batteries
3
4
1
2
6
5
7
