34
A
Appendix A: Gas Type Conversion
Revision 1/
© Moffat Ltd, January 2007
Blue Seal Evolution Series Gas Chargrills
Conversion Procedure
NOTE:
•
These conversions should only be carried out by qualified persons. All connections must
be checked for leaks before re-commissioning appliance.
•
Adjustment of components that have adjustments/settings sealed (e.g. paint sealed) can
only be adjusted in accordance with the following instructions and shall be re-sealed
before re-commissioning this appliance.
•
For all relevant gas specifications refer to the table at the end of this section.
G594 / G596 / G598 Models Only
Main Burners
1.
Remove the gas control knobs from the front control
panel. The control knobs are a push fit onto the
shaft of the gas control valves.
2.
Remove the front control panel by slackening the 2
screws on the front lower edges of the control panel
and remove the panel from the front of the
Chargrill.
3.
Remove the Chargrill castings/griddle plates and
inner radiants to reveal the burners.
4. Carefully push the main burners forwards and
negotiate between the shield brackets fitted over the
end of the burners and remove the burners from the
Chargrill to reveal the main burner injectors.
5. Unscrew the main burner injectors from the
Chargrill using a 13mm /
1
/
2
“ A/F spanner.
6.
Determine the correct injector sizes for the corre-
sponding gas, from the rating plate affixed
behind the control panel next to the manifold test
point.
7.
Replace with the correct size injectors.
8.
Refit the main burner castings, griddle plates and
inner radiants to the Chargrill.
C
AUTION
:
Ensure that the Unit is isolated from the gas supply before commencing
servicing.
Piezo Igniters
Gas Control Valves
Fig 8
Pilot Burners
Gas Control Valves
Fig 9
Fig 10
Main Burner
Shield
Brackets
Fig 11
Unscrew here with
13mm Spanner
Main Burner
Injector
