Blue Seal E9311, Service Manual

Page: 32 / 50

-32-
Revision 4/F3544
Convection Oven © Moffat Ltd, April 2005
Figure 6.3.26
15 Amp Fuses
6.3.17 INNER GLASS
1) Remove the outer glass as above.
Uncrimp the retaining lugs of the window
spacer and remove the spacer and glass.
2) To replace, ensure the silicone rubber
seal has not been displaced. Clean the
glass and refit it. Place the window
spacer in position and crimp the retaining
lugs over to hold the glass in place. Refit
outer glass as above.
Retaining
Lugs
Figure 6.3.25
6.3.19 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and
pull forward until they unclip
3) Refit new seals.
NOTE: Fit top and bottom seals first, with
open side of seal facing downwards. Fit
side seals with open side facing outwards.
Door Seals
6.3.20 DOOR PIVOT BUSHES
1) Remove door as per steps one to three of
section 6.3.16.
2) Door bushes can now be removed and
replaced.
3) Reinstall door by reversing steps one to
three of section 6.3.16.
Door Pivot
Bush
Figure 6.3.27
6.3.18 INNER GLASS SEAL
1) Remove the door inner glass (refer
6.3.18).
2) The inner glass seal can now be removed
and replaced.
NOTE: When fitting new seal, ensure join is
at top of door.
6.3.21 COOK TOP FUSES
1) Remove two screws securing the fuse
cover panel to the rear of the unit.
WARNING: DO NOT TOUCH THE
FUSES UNLESS THE POWER SUPPLY IS
SWITCHED OFF AT THE WALL.
2) The fuses can now be removed and the
fuse wire replaced as required.
Two Screws
Figure 6.3.29
Figure 6.3.28