Blue Seal E9311, Service Manual

Page: 35 / 50

-35-
Revision 4/F3544
Convection Oven © Moffat Ltd, April 2005
6.4.3 DOOR ALIGNMENT
6.4.2 DOOR MICROSWITCH ADJUSTMENT
1) Open oven door.
2) Remove service panel (refer 6.2.2).
3) With fingers, bend actuator arm of
microswitch so that switch operates when
door is in closed position.
1) Alignment of the door can be achieved by
loosening the two hex head bolts securing
the bottom plate to the oven body. The
plate may now be moved sideways or in/
out to achieve correct door alignment.
(Door should be parallel to bottom plate
and touching oven seal evenly). When
correct tighten bolts.
2) To adjust the door catch, loosen locknut
and turn the slot (using the tool supplied
with the unit); anticlockwise to increase
roller height, clockwise to decrease roller
height.
Actuator Arm
Figure 6.4.6
Locknut
Figure 6.4.8
Two Hex Head Bolts
Figure 6.4.7
6.4.4 HOLD TEMPERATURE ADJUSTMENT
1) The hold temperature of the oven can be
adjusted by turning the hold thermostat
dial to the desired hold temperature. This
dial is located inside the control panel.
Hold Thermostat
Dial
Figure 6.4.9
6.4.5 60 MINUTE TIMER ZERO POSITION
ADJUSTMENT
1) Remove 60 minute timer knob by pulling it
firmly away from control panel.
2) Open control panel (refer 6.2.1). Loosen
two screws on control panel holding 60
minute timer.
Two Screws
Figure 6.4.10
3) The timer can now be rotated as required
to ensure that the buzzer sounds at the
zero position.
Adjustment
Tool