Blue Seal E9311, Service Manual

Page: 7 / 50

-7-
Revision 4/F3544
Convection Oven © Moffat Ltd, April 2005
this is not carried out, uneven cooking could
occur). The feet/legs used with bench or floor
mounting are adjustable and will require
adjusting in levelling the unit. It should be
positioned so the operating panel and oven
shelves are easily reachable for loading and
unloading.
BEFORE USE
Operate the oven for about 1 hour at 200°C
(400°F) to remove any fumes or odours which
may be present. Operate the element on HI
for about three minutes. This will produce
some smoke which will soon disappear.
ELECTRICAL CONNECTION—OVEN
E9311 convection ovens are supplied with
pre-fitted cords. Ensure unit is fitted with the
correct cord and plug for the installation.
Refer specifications section.
It is most important that the oven is installed
correctly and that the operation is correct
before use. Installation shall comply with local
electrical, health and safety requirements.
BEFORE CONNECTION TO POWER
SUPPLY
Unpack and check unit for damage and report
any damage to the carrier and dealer. Report
any deficiencies to your dealer. Fit the legs
which are packed inside the oven. Fit door
handle to oven door. Check that the available
power supply is correct to that shown on the
rating plate located on the right-hand side
panel (figure 2.3).
Oven
230-240 V AC, 50 Hz, 13.0 A, 3.1kW @ 240 V
Hob
230-240 V AC, 50 Hz, 13.0 A, 6.5kW @ 240 V
2. INSTALLATION
IMPORTANT: THE OVEN VENT
LOCATED ON THE CABINET TOP
MUST NEVER BE OBSTRUCTED.
WARNING: THIS APPLIANCE MUST BE GROUNDED.
LOCATION
To ensure correct ventilation for the motor,
and controls the following minimum
installation clearances are to be adhered to:
Rear
25mm / 1”
Left-hand side 25mm / 1”
Right-hand side 25mm / 1”
Figure 2.1
WARNING: THIS APPLIANCE HAS
INDEPENDENT ELECTRICAL CIR-
CUITS FOR THE OVEN AND HOB.
SEPARATE POWER CONNECTIONS
ARE REQUIRED.
Should changing of the cord be necessary,
gain access to the electrical connection
terminal block and strain relief by removing
the back panel (four screws).
ELECTRICAL CONNECTION—HOB
To access the electrical connection terminal
block, remove the back panel of the hob (six
screws).
WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED
OUT BY QUALIFIED PERSONS ONLY.
Position the oven in its allocated working
position. Use a spirit level to ensure the oven
is level from side to side and front to back. (If
L1 L2 Ground
Phase Neutral
RED
BROWN
BLACK
GREEN/YELLOW
GREEN
WARNING:
THIS APPLIANCE MUST
BE GROUNDED / EARTHED
BLACK
BLUE
WHITE