6
SHAFT
1. Remove the protection cap from the
lower shaft (22) (Fig.4).
2. Align the lower shaft (22) with the
clamp (15) so that the slot is
orientated to the slot in the clamp (15)
(Fig. 5).
3. Press the locking lever (17) and
insert the lower shaft (22) into the
upper shaft (23). The locking lever
must engage in the slot of the lower
shaft (Fig. 6).
4. Secure the connection by tightening
the locking knob (16) (Fig. 6).
SAFETY GUARDS
1. Loosen the bolts with the hex
key 6 mm (18) and remove them
together with the washers ,
spring washer .
2. Please the safety guard (19) to
bracket (19A). Secure the safety
guard (19) with the hex
key 6 mm. (Fig.7)
CUTTING OPTIONS
You will be required to assemble the
relevant cutting head to suit the
intended use of the product.
BRUSH CUTTER BLADE
1. Ensure that the safety guard (19) is
attached.
2. Locate the backing flange (32) on
the spindle (31).
3. Rotate the backing flange until its
hole is aligned with the notch in the
gear head.
4. Loosen the nut (36) and remove the
washer (35) and locking flange (34).
5. Fit the cutter blade (33) onto the
spindle (31) ensuring that the
directional arrows on the guard and
the cutter blade match. Ensure that
the cutter blade sits flush on the
extruded ring on the backing flange.
6. Place the locking flange (34) and
the washer onto the cutter blade
(33).
7. Secure the cutter blade (33) with
the nut (36) (Fig. 8).
TRIMMER HEAD
1. Make sure that the safety guard
(19) has been attached properly.
2. Locate the backing flange (32) on
the spindle (31).
3. Rotate the backing flange until its
hole is aligned with the notch in the
gear head.
4. Screw the trimmer head (37) on
the spindle (31) (Fig. 9).
WARNING: Do not attach the
locking flange (34) when using
the trimmer head.
FUEL
1. This product is equipped with a 2-
stroke engine (1).
2. Mix a regular-grade unleaded gas
and a quality 2-cycle motor oil for
air cooled 2-stroke engines.
3. Do not use BIA or TWC (2-stroke
water-cooling type) mixed oil.
4. The recommended mixing ratio
for fuel:oil is 40:1 (Fig.10)
Note: Never mix fuel and oil directly
in the tank of the product.
WARNING: This product is not
supplied with fuel in the engine.
Before operating this product it
is essential to fill with fuel.
WARNING: Ensure that there are
no open flames around the
product. Do not smoke while
filling with fuel and oil.
FIG. 10
FIG. 11
1-800-348-5004
19
18
FIG. 7
19
31
32
33
34
35
36
FIG. 8
32
37
FIG. 9
FIG. 10
19A
31
19
