8
PRIMER
Use the primer (8) when starting the
product with a cold engine (Fig. 13).
RECOIL STARTER
1. The recoil starter handle (5) is
positioned at the back side of the
engine unit.
2. Pull on the recoil starter handle (5)
to start the engine (Fig. 14).
WARNING: Do not suddenly release
the recoil starter handle. Always
allow it to return under controlled
tension. Do not pull out the recoil
starter BEYOND THE RED COLOR
BAND at the end of the recoil
starter (Fig. 14).
HAND GRIP CONTROLS
There are four controls at the hand
grip with the following functions (Fig.
15).
1. Adjust the engine speed with the
throttle control (27).
2. Use the
)
8
2
(
for temporarily setting the throttle in a
partially open position, to aid starting.
3. The ignition switch (29) electrically
starts or stops the engine.
4. The throttle interlock (30) prevents
unintentional activation of the throttle
trigger until manually released.
HARNESS
1. The harness (14) helps the operator
to carry the product.
2. To remove the harness from the
loop (26), open the securing clip.
3. Place the harness so that it runs
over the left shoulder, crossing the
chest and back. The securing clip
must be located at the right hip (Fig.
16).
4. Adjust the length of the harness (14)
so that the hook is approximately 6 in.
below your waist; locate the product
to the harness by using the securing
clip ensuring that the angle of the
cutting head is parallel to the surface
being cut.
WARNING: Always attach the
product to the harness. Do not
carry it only with your hands.
5. In case of emergency, release the
product from the harness by opening
the securing clip.
AUXILIARY HANDLE
Adjust the position and angle of the
auxiliary handle (12) on the upper
shaft (23).
1. Loosen the bolts on the bracket (13)
and adjust the position and angle
(Fig. 17).
2. Afterward, tighten the bolts.
CUTTING HEADS
Blade
The cutter blade (33) is used to cut
heavier weeds, brush, and similar
vegetation with a thickness of up to
20mm.
Trimmer Head
1. The trimmer head (37) is used to
cut smaller types of weed, lawn grass,
or similar soft vegetation.
2. The trimmer head is equipped with
a bumper (38) helping to cut the
trimming line (39) while operating.
Simply tap the bumper on a firm
surface and the spool will release
fresh trimming line (Fig. 18).
3. A knife (20) is integrated with the
safety guard (19) and this will cut the
line to the necessary length.
WARNING: The cut line will be
thrown out. Danger of injury
especially for bystanders.
SAFETY GUARD
1. The safety guard protects the
operator against thrown objects
during operation.
2. The safety guard (19) is equipped
with a knife (20) that cuts the
trimming line (39) if required (Fig.19).
Note: Always remove the knife
protection before use and replace
when work is completed.
FIG. 12
FIG. 13
FIG. 14
FIG. 15
FIG. 16
1-800-348-5004
starter aid button
