26
Blue Coat SG200 Series
Figure 2-13: Initial Setup—Page Four
Page 5 displays. This page explains how to access the SG200 from an SSH Client or with a Web
browser. See
Section E: “Logging on to the SG200
on page 37 for more information.
Figure 2-14: Initial Setup—Page Five
9
To log in to the serial console right away, press <Enter> three times.
A menu displays offering two choices:
1) Command Line Interface
2) Setup Console
10
Access the CLI or Management Console:
❐
Enter
1
in the serial console menu to select the CLI.
See
on page 38 for information about using the SG200 CLI.
❐
To access the SG200 Management Console, enter the following address into your Web browser:
https://
proxysg_IP
:8082/
where
proxysg_IP
is the IP address that you configured for this SG200.
Section E: “Logging on to the SG200
on page 37 for more information about accessing the SG200.
When you have set the basic networking parameters and connected the SG200 to the network, you are
ready to fully configure the appliance. For a list of all CLI commands, refer to the
Blue Coat ProxySG
Command Line Reference
. For information about configuring and administering the SG200 (including
information about setting policies that will explicitly grant or deny proxied transactions), refer to the
Blue
Coat ProxySG Configuration and Management Guide Suite
.
--------------------- (page 4 of 5) --------------------
Press <ESC> at any time to return to the main menu
DIRECTIONS:
This setup console is used to configure a proxy forwarding host as
the forwarding default (a one member default fail-over sequence).
After assigning a host alias and the host name you can connect to the
command line interface to perform additional management tasks.
Would you like to setup the forwarding host now? Y/N [No]
N
--------------------- (page 5 of 5) --------------------
DIRECTIONS:
The ProxySG Appliance has been successfully configured to use IP
address: "10.25.36.47"
You can connect to the command line interface or Web interface to
perform additional management tasks.
To connect to the command line interface, open the following location
from your SSH application: 10.25.36.47
To connect to the Web management interface, go to the following
location with your web browser: https://10.25.36.47:8082/
--------------- CONFIGURATION COMPLETE -----------------
Press "enter" three times to activate the serial console
