10
General operating instructions
Switching the system on/off
To switch your TravelPilot on press the blue
ON
button
2
in the center
of the volume control
3
.
The system will begin to play the audio source which was active last at the
power-on volume level. Refer to the section on “Adjusting the power-on/traffic
message volume and GALA” in the chapter on Set-up.
Switching the system on/off with the vehicle ignition
If the system has been installed correctly, you can switch it on and off with the
vehicle ignition.
Switching the unit on when the vehicle ignition is switched off
If the TravelPilot has been installed correctly, you can also operate it when the
ignition is switched off.
Press the
ON
button
2
.
The TravelPilot will switch on. After the unit has played for an hour, it will switch
off automatically to prevent the vehicle battery from running down. You can re-
peat this process as often as desired. This time limit will be deactivated if you
switch on the ignition.
Note:
To prevent the TravelPilot from being used after it has been discon-
nected from the vehicle battery, you can activate the security cod-
ing for your TravelPilot.
If the security coding has been activated, you will always be required
to enter the code after the vehicle battery has been disconnected,
after the system has been disconnected from its power supply (e.g.
if stolen) and after a fuse has blown. For information on how to ac-
tivate/deactivate the coding, please refer to the section on “Activat-
ing the equipment coding” in the chapter on Set-up.
1 RNS 150 gb
18.02.2000, 9:58 Uhr
10
