13
4.4
Manual moving of the machine
To move the machine manually push the treadle up with your foot. The wheels are now disengaged from the
drive motors. The machine can now be pushed around on its wheels.
Make sure that the floor is flat, because the machine is uncontrolled now!
It is very dangerous to drive the
machine on a grade or ramp when the treadle is in upwards position!
Never load or unload the
machine on a ramp or incline when the wheels are in the disengage mode. Failure to do so could cause
machine to runaway, damage to the machine, damage to property or cause serious injury.
Push the treadle down when parking the machine, engaging the wheels to the drive system will act like a
parking brake when the machine is turned off.
The machine should only be moved around when the dust hose, and power supply cable are disconnected.
WARNING!
Always make sure all rotating parts have come to a complete standstill before moving around the
machine.
Be careful! Make sure nobodies feet get under the wheels. Wear appropriate safety shoes when you drive the
machine to or from the work area.
Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable and the dust
hose.
4.5
Removing the drum
Make sure all moving parts of the machine have come to a
complete standstill before changing the drum. Pull out the key
of the deadman’s switch and put it in your pocket.
Warning!
Always wear Personal Protective Equipment!
The dust can be hazardous to the health!
Wear a dust mask! Wear protective gloves!
1.
Loosen the 4 bolts of the side plate
2.
Remove the side plate (2)
3.
Pull the drum from the axle, and support the drum.
4.6
Mounting the drum
Clean the hexagon axle inside the machine and lubricate it over the whole length.
Slide the drum over the axle until it will not go any further.
Mount the side plate. A side plate which is incorrectly mounted or mounted with force, will shorten the
lifetime of the drum bearings.
Always check the belt tension after mounting a drum (see chapter 6.2).
Never use the machine without a side plate or with an incorrect mounted side plate!
