A
A S
S S
S E
E M
M B
B L
L Y
Y
&
&
D
D II S
S A
A S
S S
S E
E M
M B
B L
L Y
Y
A s s e m b l y
&
D i s a s s e m b l y
BODY DISASSEMBLY
(continued)
9. Tilt front end of Encapsulated Ram Sleeve Up, and allow ram to slide out from rear.
NOTE:
BEFORE reinserting the Ram, be sure to clean the inside of the ram sleeve
with a Q-tip and inspect the internal O-ring located toward the front of the Ram Sleeve.
Check for excessive wear and/or damage. If the O-ring needs to be replaced,
carefully remove it using a dental pick or the like, and replace. Be sure to lubricate
the internal O-ring with Dow 55 before reinserting Ram.
10. Turn Body over to expose bottom of marker body and remove Valve Retaining Screw.
11. Remove the Valve through front end of the Marker Body.
(
Gently push the Valve from the rear with a barrel swab)
12. Remove Feedneck from Body.
NOTE:
At this time the Body is disassembled. Listed on the following page are key points to remember during assembly.
III.
BODY DISASSEMBLY
First: Ensure Barrel of Marker is removed.
a
1. Remove both Eye Sensor Covers (one on each side) by removing Retaining Screw.
a
2. Remove both Eye Sensors (one on each side) by carefully pulling sensor heads from mounting holes.
a
3. Lift up on Bolt Retaining Pin and slide Bolt out of rear of Marker.
4a. Unscrew Encapsulated Ram Sleeve Assembly from Marker Body. (turn counter-clockwise)
4b. Remove Encapsulated Ram Sleeve Assembly by sliding it out from rear of Marker Body.
a
5. Remove E-clip from front of Ram.
a
6. Remove Slotted Bolt Pin Receiver. (turn counter-clockwise)
a
7. Remove Delrin Bolt Pin Receiver Spacer. (turn counter-clockwise)
a
8. Unscrew Ram Sleeve End Cap from Ram Sleeve.
Remove Eye Sensor Covers
1
Remove Eye Sensors
2
Remove E-clip from Front of Ram
5
Remove Slotted Bolt Pin Receiver
6
Remove End Cap from Ram Sleeve
8
Tilt Ram Sleeve Up and Remove Ram from Rear
9
Remove Valve through Front
Remove Valve Retaining Screw
10
11
Remove Feedneck from Body
12
Lift Bolt Pin and Remove Bolt
Unscrew Ram Sleeve
Remove Ram Sleeve Assembly
3
4a.
4b.
Remove Delrin Bolt Pin Receiver Spacer
7
2
defiant
16
15
Defiant 2 Manual ƒ 5/31/05 5:47 PM Page 17
