A
A S
S S
S E
E M
M B
B L
L Y
Y
&
&
D
D II S
S A
A S
S S
S E
E M
M B
B L
L Y
Y
A s s e m b l y
&
D i s a s s e m b l y
REGULATOR DISASSEMBLY
(continued)
HIGH-PRESSURE REGULATOR (HPR)
1. Unscrew Allen Adjuster.
2. Unscrew Lower End of (HPR)
High-Pressure Regulator Housing.
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
NOTE:
At this time the Regulators are disassembled. Listed below are key elements to
remember during assembly.
1. Piston: Ensure cupped end of Piston is facing towards Pin Valve.
2. Pin Valve: Ensure Pin Valve is not bent and seats in cupped end of Piston.
Failure to do so will cause Regulators to function improperly.
3. Air Barb: Ensure fiber washer is on Air Barb base when installing.
This will ensure Air Barb does not leak.
4. Poppet Spring Attachment: Ensure small end of Spring sits firmly on Poppet.
5. ASA Receiver: Place small portion of Loctite on Retaining Allen when installing.
This will ensure ASA Receiver does not work itself loose during operation.
4. LPR Retaining Screw: Place small portion of Loctite on Retaining Allen when installing.
This will ensure LPR (Low-Pressure Regulator) does not work itself loose during operation.
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9. Remove Spring from Upper Reg. Housing.
10. Upper End of (HPR) High-Pressure
10.
Regulator Housing.
Torpedo/High-Pressure Regulator
LOW-PRESSURE REGULATOR (LPR)
1. Unscrew Allen Adjuster.
2. Unscrew LPR End Cap (Part 2) from
Low-Pressure Regulator Base (Part 10).
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
Low-Pressure Regulator
3
5
4
8
6
7
9
10
1
2
7
4
3
8
5
6
9
10
1
2
II.
REGULATOR DISASSEMBLY
1. Remove High-Pressure Regulator to gain
proper clearance to the LPR Retaining Screw.
2. Remove LPR Retaining Screw from Body.
3. Slide LPR Assembly from Body.
Remove Spring and Poppet
Remove ASA Retaining Screw
Transfer Hole Screw
4
Remove HPR
1
5
Remove LPR Retaining Screw
2
6
Slide LPR Assembly from Body
3
2
defiant
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9. Remove Spring from Upper Reg. Housing.
10. Low-Pressure Regulator Housing/LPR Base.
4. Remove Spring and Poppet Assembly.
5. Remove ASA Receiver Retaining Screw.
6.
NOTE:
The Transfer Hole Screw will only need to
be removed if a leak is detected, or a great deal
of debris is present.
14
13
Defiant 2 Manual ƒ 5/31/05 5:46 PM Page 15
