RackSwitch G8264 Installation
BPP-00039-00 rev 2, January 2011
Chapter 1: RackSwitch G8264 Description and Specifications
11
Reset Button
The Reset button is recessed within a hole on the front panel. Use a straightened paper clip or
similar object to press the Reset button. The Reset button allows technicians to reset the switch, as
follows:
Press
Reset
: The switch resets and reloads the configuration files.
Press and hold
Reset
for five seconds: The switch resets and configures all settings
to factory defaults.
Fans
Four internal fan modules cool the switch unit. If an individual fan module fails, the other fans
continue to run, and the switch unit continues to operate normally. These hot-swap fan modules can
be replaced by the customer.
Fan operation and internal temperatures are monitored. If the air temperature exceeds a desired
threshold, the environmental monitor displays warning messages.
Note –
If a fan module fails, the maximum operating temperature drops from
+40ºC
to
+35ºC
.
The Service ( ! ) LED blinks and the Fan LED blinks if there is a failure of one or more fan modules.
The failed fan module’s LED (rear panel) blinks to indicate a failure.
AC Power Supply
The G8264 has two redundant 450W AC power supplies. Each internal power supply has an
individual IEC 320 power connector on the rear panel. The power cord attaches to a universal
grounded AC power source. Power supplies are hot-swappable and can be replaced by the
customer.
Each power supply can be connected to a separate AC circuit to mitigate the risk of down time
during a power failure. When used in a redundant configuration, the dual power supplies have a
load-sharing capability that allows each supply to operate at approximately 50 percent of full load.
Using redundant power can minimize the power disruption during a power supply failure and
extend the expected lifetime of each supply by operating normally in a conservative power mode.
There is no power switch on the G8264; the switch unit powers up when power is supplied through
the power cord(s).
The Power Supply LED indicates the status of the power supplies. The LED blinks when only one
power cord is connected, and lights steady when both power cords are connected.
Caution—
To reduce the risk of electric shock, use only power cords that have a grounding path,
and always connect the power cord to a properly grounded power outlet.
