BLADDERSCAN BVI 9400, Operation & Maintenance Manual, Page: 58 / 84

50
11. If necessary, use the following orientation in order to re‑aim the probe, and then re‑scan the patient:
• The small dot at the base of the crosshairs represents the feet of the patient.
• The top of the crosshairs represents the patient’s head.
• The upper left quadrant represents the patient’s right shoulder.
12. If you would like to save the exam data, continue to the next procedure.
PROCEdURE 3. SAVE, REVIEW, & PRINT EXAM RESULTS
In order to save the scan, you must record an annotation. If you do not record an annotation, the scan
result will be lost, and the next scan you perform will overwrite the non‑annotated scan.
IMPORTANT
After performing a scan, you can save the results by recording a voice annotation. Be sure to include all
relevant scan information, the patient’s name, and the name of the person performing the scan. The
annotation cannot exceed 10 seconds in length.
The instrument can store ten scans with voice annotations. If you are using the optional Scan Point
®
with
QuickPrint software, the exams will be automatically transferred and saved in Scan Point once you have
connected the instrument to the software. For more information about using Scan Point with QuickPrint,
please refer to Scan Point user documentation, contact your local Verathon representative, or contact
Verathon Customer Care.
Note: If the instrument battery runs low or the instrument goes into sleep mode, any non‑annotated exam
data is lost. However, the instrument does not erase any annotated exam results when it goes into sleep
mode. To make sure you do not lose any patient data, add a voice annotation to every patient exam.
RECORd A VOICE ANNOTATION (OPTIONAL)
1. On the console, press and release the
Record
button .
2. Hold the probe approximately 15 cm (6 in) from your mouth, and then record the patient information by
speaking clearly into the probe microphone located just above the aiming display on the probe.
3. When you are finished recording, press the Stop button . An hourglass icon appears to indicate that
the scan is being saved.
4. Press the
Listen
button . The voice annotation plays.
If you are not satisfied with the recording and want to re‑record it, repeat Step 1 through Step 4.
Note: You can make a new recording only if the instrument still displays the bladder volume for that
particular exam.
If desired, the instrument is ready to perform another scan.
REVIEW OR PRINT AN EXAM (OPTIONAL)
5. On the console, press the
Review
button .
Note: You must record a voice annotation in order to review the results.