TROJAN.
INSTRUCTION MANUAL
17
1. Using a modeling knife, cut away the
covering from the fuselage for the stabilizer
and remove it.
.
HORIZONTAL STABILIZER
INSTALLATION.
Remove covering.
Mark point
3. Mark the shape of the vertical on the left
and right sides onto the horizontal stabilizer
using a felt-tip pen
2. Draw a center line onto the horizontal
stabilizer. Then slide the horizont al into the
fuselage.
Removing the elevator out the horizontal fin.
Center line.
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering it’s self.
Cutting into the balsa structure may
weaken it. This could lead to possible
failure during flight
4. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
Remove covering
