TROJAN.
Instruction Manual
4
C/A glue
C/A glue
2) Using a modeling knife, remove the cov-
ering at possition show below.
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Aileron
servo tray
Servo
wire.
Thread.
Remove
covering
Bottom of wing.
Secure
4. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into aileron
servo tray as same as picture below.
Bottom of wing.
Bottom of wing.
