TROJAN.
Instruction Manual
22
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizont al stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 degree
to the horizontal stabilizer.
1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
Remove covering.
2. Slide the rudder into the fuselage as
same as picture below.
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
Hinge slot.
Remove covering.
Mark point
