TROJAN.
INSTRUCTION MANUAL
23
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Epoxy glue.
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the vertical
stabilizer mounting area. Apply epoxy to the
lower rudder hinge. Set the stabilizer in place
and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceeding.
C/A glue
C/A glue
Rudder control horn install as same as the
way of aileron control horn. Please see pictures
below.
RUDDER CONTROL HORN INSTALLATION.
C/A glue
