TROJAN.
Instruction Manual
10
INSTALLING THE RECEIVER AND BATTERY.
3) Do not permanently secure the re-
ceiver and battery until after balancing the
model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
1) Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2) Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a rubber band or masking tape
to hold the foam in place.
Front view.
Motor.
Rotor shaft.
C/A glue
Push.
Rubber band.
