TROUBLESHOOTING
SERVSWITCH MULTIVIDEO INSTALLATION AND OPERATIONS MANUAL
31
TROUBLESHOOTING
Computer does not boot, keyboard or mouse error received.
¾
Cable is loose, reseat cable and on PC hit F1 to continue or reboot
computer.
¾
Wrong cable or keyboard and mouse cables reversed.
¾
Cable is defective; try using cable from another computer.
¾
Port on the ServSwitch MultiVideo is defective; try using another port
If the problem goes away port is defective.
¾
Port on computer is defective, try plugging in keyboard or mouse
directly if problem remains computer port is defective. If power status
LED not lit, fuse on motherboard may be blown.
¾
Computer keyboard and mouse not configured.
Mouse driver does not load.
¾
If PS/2 type mouse, computer must be connected to ServSwitch
MultiVideo at boot-up time in order for the mouse to be recognized by
the computer. Reboot computer with ServSwitch MultiVideo powered
on and cable attached.
¾
Computer keyboard and mouse not configured.
Can’t switch computers from keyboard
¾
Power to the ServSwitch MultiVideo was removed for less than three
seconds possibly causing keyboard to lock up. Disconnect and re-
connect the keyboard.
¾
If PS/2 type keyboard and mouse, cables may be reversed.
¾
Not using left control key. Using numeric keypad instead of keys on top
row. Not releasing control key before typing in number. Waiting more
than 2 seconds to enter computer number. Using caps lock or shift key.
Wrong or missing characters from those typed
¾
For PCs, the mode of the keyboard does not match that of the
computer. Issue the mode command, usually 1 for IBM PS/2s, 3 for
Unix computers, and 2 for all others. The default setting is mode 2.
Sometimes an incorrect mode will confuse the computer or keyboard
and require re-booting the computer or resetting the keyboard by
unplugging and plugging it back in.
Switch to Switch failure
n
Verify the firmware in all like switches is the same revision.
Mouse does not move
¾
Mouse not configured.
¾
ServSwitch MultiVideo turned off after or not connected when computer
booted or application using mouse run. Exit and re-enter application
using mouse or issue reset command.
¾
PS/2 mouse was not connected when ServSwitch MultiVideo powered
up or disconnected and reconnected. Issue the reset command or
reconfigure the mouse.
Summary of Contents for ServSwitch KV0202A
Page 1: ......
Page 45: ...NOTES MULTIVIDEO INSTALLATION AND OPERATIONS MANUAL 42...
