OPERATION
SERVSWITCH MULTIVIDEO INSTALLATION AND OPERATIONS MANUAL
28
Selecting a computer
To connect to a computer, you can select it from the front panel, select it by
keyboard commands, or select it through the RS232 serial port.
Selecting a computer from the front panel
Using the - and + buttons on the front panel will switch to the previous (-)
computer port or advance (+) to the next computer.
Selecting a computer using keyboard commands
Press and release the left control <Ctrl> key, then enter the computer port
number. Pressing and releasing the left control <Ctrl> key then the + or -
key will advance forward or backwards one sequential port.
Selecting a computer through the RS232 port
Selecting a computer can be done through the RS232 port if needed.
Contact Black Box for details.
Reset to factory defaults
To reset the ServSwitch MultiVideo to the original factory default settings,
first, power down the unit, press and hold the – (minus) switch in and turn
the unit’s power on. Keep the – (minus) switch held in until the unit
switches to the last port on the unit (port 2, 4, or 8). If you release the –
(minus) switch before the last port is switched to, the defaults will not be
restored.
Rackmounting
The ServSwitch MultiVideo can be rack mounted using a our Rackmount
kit. See Appendix D and E for instructions and Appendix B for part
numbers.
Summary of Contents for ServSwitch KV0202A
Page 1: ......
Page 45: ...NOTES MULTIVIDEO INSTALLATION AND OPERATIONS MANUAL 42...
