724-746-5500 | blackbox.com
Page 61
Appendix: SNMP Events Table
Appendix: SNMP Events Table
Table A-1 lists all events recorded.
Table A-1. Events recorded.
Event Test
Code
Comment
“System Boot”
1010
Reported upon device bootup.
“Server Busy ask for
disconnect”
1030
Attempt to connect when another user is already connected. The second user has permission for takeover, sent before
the second user actually takes over the session.
“User login
succeeded”
1040
On every successful user login to the device.
“Login failed wrong
user name or
password”
1050
Login failed because of wrong user name or password.
“Login not
succeeded server
busy”
1060
Login denied since a user with higher permission is connected (takeover not allowed).
“Logout”
1070
User logout (end of remote access session).
“Disconnected by
another user”
1110
Takeover has been successfully performed. The previous user has been disconnected.
“Hardware failure”
1200
Device internal hardware failure. Try disconnecting any other attached device and reboot. If the problem persists, contact
Black Box Technical Support at 724-746-5500 or [email protected].
“Hard reset power
cycle command”
1220
Power cycle command issued. Thsi is only relevant when a special power-cycle product is attached to the device.
“Viewer login”
1230
User connected in view-only mode (while another user is connected in a regular session).
“Viewer logout”
1240
User connected in view-only mode has been disconnected.
“Global access
disabled”
1250
Device has been blocked for access by an administrator; remote access is disabled until the device is unblocked.
“Block User
Account”
1260
User blocked because of too many login attempt failures per policy in configuration.
“Successful user
login”
2010
Successful user login CONF_USER_EVENT_LOGIN_SUCCEEDED.
“Login is not suc-
cessful—wrong
user access level”
2020
Login is not successful—wrong user access level. CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_LEVEL
“Wrong user name
or password”
2030
Wrong user name or password. Login is not successful. CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_USER_
NAME_OR_PASSWORD
“Login is not
successful because
server is busy”
2040
Login is not successful because server is busy. CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_SERVER_BUSY
Summary of Contents for ServReach KVMultiport KVMoIP
Page 63: ...Page 63 NOTES...
