50
CHAPTER 5.
USAGE
must make sure, it is not interfering with the IP settings of RAS-PutIn and your console
computer. The default value will work in most cases.
5.5.7 ISDN Settings
In addition to the standard interfaces, RAS-PutIn offers remote access using an ISDN connec-
tion
Logically, connecting to RAS-PutIn using an ISDN line means nothing else than building up
a dedicated point to point connection from your console computer to RAS-PutIn. With other
words, RAS-PutIn acts as an Internet Service Provider (ISP) to which you can dial in. The
connection is established using the Point-to-Point Protocol (PPP). Before you connect to RAS-
PutIn, make sure to configure your console computer accordingly.
The ISDN settings panel (see Figure
on the next page) allows you to configure RAS-PutIn
for an ISDN connection. The according ISDN options are described below.
Enable ISDN
Enables or disables the ISDN adapter.
MSN
This Multiple Subscriber Number is assigned to RAS-PutIn. Hint: The RAS-PutIn ISDN
function does not work with empty MSN.
Layer-2 protocol
The Layer-2 Protocol (the Data Link Layer) of the ISO 7-layered architecture.
It is
responsible for the error-free movement of data between network nodes. You can choose
between the High-level Data Link Control (HDLC) and X.75. You can leave this option
untouched in case you use a standard network connection as built in Windows or Linux.
Enable hang-up timer for incoming calls
If you want RAS-PutIn to hang up an incoming connection, you have to check this box.
The time out value is configured using the next option.
Hang-up timeout
The hang-up time out measured in seconds. Normally it is valid for outgoing connections
only. That means, in case RAS-PutIn is configured for callback. In case the ‘Enable
hang-up timer for incoming calls’ option is checked, the time out will apply for incoming
calls also.
IP address range
Addresses from this range will be assigned to RAS-PutIn and the console computer during
establishing an ISDN connection. The first address will be used for RAS-PutIn itself. The
range must enclose 3 addresses at least.
Enable channel bundling
Enables or disables the channel bundling. If it is enabled RAS-PutIn can use both ISDN
channels if free and the the calling device supports it.
Last incoming call status
This shows the last incoming call values for caller number and called number. The infor-
mation can be used to check if the configured numbers (MSNs) are correctly.
4
ISDN is available for EMEA versions of RAS-PutIn only
Summary of Contents for RAS-PutIn
