_____________________________________________________________________
724-746-5500 | blackbox.com
Page 35
in rackmount models. To modify the default SNMP settings, the
Administrator
must
make the edits at the command line as described in
Chapter 15—Advanced
Configuration.
TFTP
This service will set up the default
tftp
server on the USB flash card (and is relevant
to LES1508A, LES1408A, LES1416A, LES1432A, LES1448A, LES1308A, LES1316A,
LES1332A, LES1348A, LES1208A-‐R2, LES1216A-‐R2, LES1232A and LES1248A-‐R2
console server
s only). This server can be used to store config files, and maintain
access and transaction logs, etc.
Ping
The
Respond to ICMP echos
(i.e.
ping
) allows the
console server
to respond to
incoming ICMP echo requests. Ping is enabled by default. For security reasons, you
should disable this service after initial configuration.
Nagios
Access to the Nagios NRPE monitoring daemons
(refer
Chapter 8)
NUT
Access to the NUT UPS monitoring daemon (refer
Chapter 10
)
SNMP
This will enable
netsnmp
in the
console server
, which will keep a remote log of all
posted information. SNMP is disabled by default. To modify the default SNMP
settings, the
Administrator
must make the edits at the command line as described in
Chapter 15 – Advanced Configuration
NTP
Refer
Chapter 11
Click
Apply
. As you apply your services selections, the screen will be updated with a
confirmation message:
Message
Changes to configuration succeeded.
3.4.2 Service Settings
The
Administrator
can access the
console server
, and connected serial ports and managed devices, using
a range of access protocols/services. However for each such access the particular service must first be
configured and enabled to run on the
console server
.
To enable and configure a service:
Select the
Service Settings
tab on the
System: Services
page
