Chapte
r 2: Installation
724-746-5500 l www.blackbox.com
25
Connecting power
The InvisaPC Receiver features an external power supply. A DC power jack is located on the rear
of the InvisaPC Receiver.
NOTE:
Use only the power supply provided by Black Box.
1.
Plug the external power supply’s 2.5 mm connector into the DC power jack on the
rear of the InvisaPC Receiver.
2.
Connect the detachable IEC power cord to the power supply.
3.
Plug the IEC power cord into an appropriate wall outlet.
Networked installation
The following instructions will enable you to install your InvisaPC Receiver and InvisaPC
Transmitter in a networked configuration. In this installation, multiple InvisaPC Transmitters and
InvisaPC Receivers are attached via the same Ethernet network. In this case, it is important for each
unit to be configured with a unique IP address.
InvisaPC Transmitters and InvisaPC Receivers may be configured for use on a single subnet or for
use across routers. Use of routers, however, can cause a slight increase in end-to-end latencies,
which may not be acceptable for all applications.
NOTE
: When using the InvisaPC across the Internet, the receiver’s IP address will need to have Port 3389
forwarded using the router’s “Port Forwarding.”
