50
Flash
This command will force the Terminal Server
to download new operational code and reload it
into Flash ROM. This is necessary when a new
version of software is released and you wish to
upgrade your unit. If the server cannot down-
load the file, the code in Flash ROM will still be
usable.
Help
Displays a one-page summary of available
commands and what they do.
Init 451
Reboots the Terminal Server after it has been
configured. If the Terminal Server can find and
load the specified software loadfile, it will re-
start itself with full functionality. If the loadfile
is not found, the server will attempt to reload
continuously. If there is an error, or if the con-
sole’s
Return
key is pressed, the Terminal
Server will re-enter the Boot Configuration
Program.
SET BOOTP {Enabled, Disabled}
Enables or disables the sending of BOOTP que-
ries during the boot sequence. It is enabled by
default.
SET DHCP {Enabled, Disabled}
Enables or disables the sending of DHCP que-
ries during the boot sequence. It is enabled by
default.
SET Hardware xx-xx-xx
Specifies the last three numbers of the server’s
Ethernet address. The first three numbers will
be supplied automatically.
The Ethernet address should have been set at
the factory. Setting an incorrect address could
cause serious network problems.
SET IPAddress ip_address
Specifies this server’s IP address. Uses the stan-
dard numeric format.
SET Loadhost ip_address
Specifies the host to attempt to load the file
from. The IP address should be in standard nu-
meric format (no text names are allowed).
SET RARP {Enabled, Disabled}
Enables or disables the sending of RARP que-
ries during the boot sequence. It is enabled by
default.
Summary of Contents for 16-Port Rackmount 10/100
Page 90: ......
