46
The terminal shows a
Boot> prompt rather
than a Local>
prompt.
The Terminal Server is not con-
nected properly to the Ethernet.
Ensure that the Terminal Server is firmly
connected to a functional and properly-
terminated network node.
The Terminal Server Ethernet
address is invalid.
The Terminal Server Ethernet address is
located on the bottom of the unit. Use the
Change Hardware
command to set the
correct address, then reboot.
Init Noboot
command was
entered.
See
Modem Configuration Checklist
on
page 48.
The Terminal Server
passes power-up
diagnostics, but
attempts to download
new Flash ROM
code from a network
host.
If the OK LED blinks rapidly,
the Flash ROM code may be
corrupt.
Reboot the unit. If you get the same mes-
sage, you will need to reload Flash ROM.
See
Reloading Software on page 56
.
If you did not request a TFTP
boot, the flash ROM code is
corrupt. The unit will remain in
boot mode.
Table 11-1:
Power-up Problems and Error Messages, cont.
Problem/Message Error
Remedy
Summary of Contents for 16-Port Rackmount 10/100
Page 90: ......
