BKI BLG-TC Series, Operation Manual

Page: 13 / 62

Gas Auto-Lift Fryer Installation
11
Use appliance connectors and quick-disconnect devices that are in compliance with the
applicable ANSI and CSA standards.
3. Attach an appliance connector to the fryer according to the instructions provided by the appliance
connector manufacturer.
4. Connect the gas supply to the fryer.
5. Lock the casters so the fryer does not move. Every time you use the fryer, make sure the casters are
locked so the fryer cannot move. (In Canada: refer to caster codes CAN 1-6.10 M88 and CAN 1-6.9
M79.)
6. Turn on the gas at the gas supply valve.
7. Check for gas leaks from the gas supply to the fryer gas valve using a soap and water solution. If a leak is
detected, tighten the connection where the leak occurs.
8. Apply power to the fryer.
9. Clean the fryer pot before filling with shortening. See boil out procedure.
10. Place the DRAIN handle in the CLOSED position.