CT-600-2
57
The Settings screen will now appear.
Select “Config.Type AI” to configure input type of the analog inputs, according to the type of sensor/signal
that is connected. To change the input type, use the “up/down” keys to select the input to be changed, then
press “OK” and use the “up/down” keys to select the correct input type. Confirm by pressing “OK” again.
From the Settings screen, select “Scale AI” to scale the analog input signals according to the sensor used
and the signal resolution used in the ACP LINK. In addition to the scale, a calibration factor can be used if
multiplication is needed for the sensor to match. To modify a value, select the desired input, then select the
value, and press “OK”. Modify the digit with “up/down” arrows, and select which digit to modify with “left/right”
arrows. Press “OK” to confirm, and the value is stored.
From the Settings screen, select “Config.Type AO” to configure the analog output type. The operation is
similar as described above the analog input type. Not all outputs of the M172 are configurable in this
application and normally it is not necessary to modify the analog outputs.
