Bison MMIB-20, Operator'S Manual

Page: 51 / 72

13. - Join the Cyclone (52) and the extension (41)
with the Cane Assembly (54). Use the screw (55),
the nut (17) and the pressure washer (18). Assemble
the third cane (56) to the ejector elbow (40) and to
the extension (41) with the screw (16) on the upper
side and with the screw (55) on the lower side. Adjust
with the nut (17) and the pressure washer (18).
Assemble the Arrow Shaft (56) with the pulley (20)
and make the proper adjustments (see page 19).
16. - 5/16’ x 3/4’ Hex. Screw
17. - 5/16’ Hex. Nut
18. - 5/16’ Pressure Washer
20. - 24-3/4 6-R Pulley
40. - Ejector Elbow
41. - Extension
52. - Cyclone
54. - Cane Assembly
55. - 5/16’ x 1’ Hex. Screw
56. - Third Cane
57. - Arrow Shaft
NOTE : The assembly described is the same for the
MMRB20 mill and the MMIB20 except for step 1.
IMPORTANT : Read the operation and maintenance
sections described in this manual before operating
the hammer mill.
ASSEMBLY
54
55
18
17
55 54
55
17
18
56
54
16
18
17
55
17
18
57
20
52
41
40
55
55
18
17
46