Bison MMIB-20, Operator'S Manual

Page: 27 / 72

FEED HOPPER OPENING REGULATION
The part that controls the feeding also has the
function of preventing the mill from getting stuck.
The feed hopper opening (A) will be regulated
according to the material to grind.
To grind pasture it opens to the maximum. To grind
grains, regulate the opening according to what you
observe, that is, if you see that at the time of adding
the grain the Mill gets stuck or a high quantity of
grains are rejected, then lower the gate until you
see that this does not occur anymore. To regulate
the feeding opening (A), loosen both screws (B)
located on the upper front part of the gate, close or
open the gate, according to your needs, and tighten
the screws.
Try not to remove the swing gate (C) if it’s not
necessary; if you do so, make sure that it gets
placed back.
ATTENTION: When you regulate the Feed
Hopper opening, be very careful not to drop any
screws into the rotor, as this can cause serious
damage to the mill.
Never remove the folding gate when the mill is
under operation.
DANGER: Do not adjust the gate of the
material inlet and do not remove the folding gate
while the mill is under operation. Also, check
that there are not foreign bodies in the rotor
area. (Screws, pins, rocks, etc.)
OPERATION
A
C
B
22