Bison MMIB-20, Operator'S Manual

Page: 37 / 72

NOTE THE LUBRICATION SYMBOLS
For your Mill lubrication, use bearing grease based
on Lithium EP-2, in hour intervals indicated in these
symbols.
Regularly brush the arrow shaft with Lithium EP-2
grease.
MAINTENANCE & LUBRICATION
ATTENTION: Do not clean, lubricate or
adjust the machine while it is in motion.
IMPORTANT: Recommended intervals are
based on normal working conditions. Severe
or unusual conditions may require more
frequent lubrication intervals.
Perform each of the lubrication and service
procedures illustrated in this section at the beginning
and at the end of the season.
Clean the grease fittings, before lubricating, with
a grease gun. Replace all broken or lost fittings
immediately. If a new grease fitting does not accept
grease, remove it and check nearby parts for
damage.
LITHIUM-BASED GREASE FOR BEARINGS
Choose the most suitable type of grease according
to the NLGI consistency and the temperatures that
may be present in the interval until the next grease
change.
You can use any grease that meets the following
standard: NLGI GC-LB.
MAINTENANCE
50 hrs