21
A/F Recover Time
When the camera is not in operation, and in manual focus mode, after the A/F RECOVER TIME has elapsed, the
camera will automatically switch to automatic focus. If the time is 0, then this function is disabled.
A/I Recover Time
When the camera is not in operation, and in manual Iris mode, after the A/I RECOVER TIME has elapsed, the
camera will automatically transfer switch to automatic Iris. If the time is 0, then this function is disabled.
Focus Near Limit
The near limit from the following: 1cm, 11cm, 30cm, 0.8m, 1.2m, 1.4m, 1.65m, 2.0m, 2.5m, 3.1m, 4.2m, 6.0m, 10m, 20m.
Day/Nite Mode
Auto: The camera will automatically turn from Day mode (Color) to Night mode (Black & White) when the lighting
condition is low enough, the camera illuminator will be turned on automatically at Night mode.
Day: The camera will remain in Day mode (Color) no matter how low the lighting condition is, the camera illuminator
will not be turned on at Night. The image may be too dark to be seen in a low light condition.
Night: The camera will stay in Night mode (Black & White) no matter how bright the lighting condition is, the
camera illuminator will be turned on all the time. The image will be stay in Black & White.
Laser
Off: Turn illumination off.
On: The illumination can be set to Day/Nite modes.
Gamma
The gamma can be set to Auto, Manual, and value from 0 to 4.
Zooming Speed
The speed of zooming can be set to value from 1 to 8.
Preset Speed
The speed of preset can be set to value from 1 to 255.
Exit
Push the joystick to the right to exit this level menu.
System Setup Menu
Factory Default
The menu is used to restore the factory settings.
Display Configuration
Zoom Lens Position: Select ON to display the zoom lens position on the screen.
Direction Indicator: Select ON to display the direction indicator on the screen.
Interface Set
Camera ID: Factory Default Setting: 001. Use RS485 Pelco-D can control up to 255 cameras, camera ID from 001
to 255 has to be set. Use RS422 VISCA protocol can control up to 7 cameras, camera ID from 1 to 7 has to be set.
Baud Rate: Select the baud rate from the following: 2400, 4800, 9600, 38400bps. Default Setting is 9600
Factory Format: Set factory default format.
