BIOS DVPro T10B3, User Manual, Page: 22 / 65

BIOS CORPORATION
－
19
－
5
．
Press the SELECTbutton
Serial No ID
xxxxxxxx
Serial number of DVPro T10 will be displayed
6
．
Press the SELECTbutton
End of
Fixed Parameter
Indicate the end of the fixed parameters.
Then, if you press the Mode button now, you will enter Background Parameter mode.
You can also get into Background Mode by pressing the Mode button during display on Firmware Version,
Vednor ID, Device ID, or Serial Number.
From here, pressing the Mode button to roll among the background parameters.
● IP Address Setup
IP Address
192.168.50.210
By pushing SELECTbutton, the IP Address will be increased.
The longer you hold the SELECT button, the faster the number is increased.
Push the MODE button to move to next field.
● Address Mask Setup
Address Mask
255.255.255.0
This is to setup IP address mask same as IP setup.
● Parity Mode Setup
ENABLE
PARITY
ENABLE*
、
DISABLE
Enable or Disable Cache memory parity. (Similar to ECC function)
● Maximum negotiatable speed of host channels
Host Rate
6Gb/s
3Gb/s, 6Gb/s*
It is important to note that the DVPro eSATA speed is not auto-negotiable. Most of eSATA rate of host
computer is auto-negotiable, so this parameter has to be equal or smaller than the esata rate of host
computer.
●NCQ MODE