BIOS DVPro T10B3, User Manual, Page: 18 / 65

BIOS CORPORATION
－
15
－
The bigger size of stripe width, faster transfer speed can be
achieved for sequential read or write. Usually
「
2MB/ DRIVE
」
setup will give a good performance but it depends on the host
application.

Setup of eSATA Host
eSATA3 Host
Enabled
Parameter Function Memo
eSATA3 Host
Enabled
Enable eSATA Host Channel Default
eSATA3 Host
Disabled
Disable eSATA Host Channel

Setup of USB3 Host
USB3 Host
Disabled
Parameter Function Memo
USB3 Host
Enabled
Enable USB3 Host Channel
USB3 Host
Disabled
Disable USB3 Host Channel Default
※
When both eSATA3 and USB3 hosts
are enabled, make sure LUN MODE set to “Swapped”

Recovery Rate Setup
RECOVER RATE
5Min. /GB
Recovery (Rebuild) operations utilize free time between host data access without interrupting the current
host application.
Therefore data read/write priority can be adjusted through different recovery rate setting.
User can choose the timing to execute recovery operations as below.
Parameter Function Memo
RECOVER
WAIT
TIME 0 Sec
Recovery request will be processed immediately between host
commands. Recovery will always be processed therefore host
access will be slow down. Select this mode if you want the
recovery have high priority.