BIOS DVPro T10B3, User Manual, Page: 14 / 65

BIOS CORPORATION
－
11
－
Write Pending Setup
：
Write delay time setup
↓
Write Verify Setup
：
Write verify setup
↓
Read Ahead Setup
：
Read ahead size
setup
2.3 Introduction of Parameters Setup
This section will explain the general parameters setup process.
To start with new configuration, the system has to enter Parameter Setup mode. Please press and hold
both
“Mode” and “Select” buttons for more than 3 seconds while turning on power. The LCD should show
message as below indicating the system in Parameter Setup mode.
ARRAY PARAMETERS
SETTING
！
You can then start to modify each parameter under this mode.
General usage of Buttons:
MODE Button: To rotate among Parameter items
SELECT Button: Select the parameter for change
●Enter Parameters Setting mode ：
MODE Button
＋
SELECT Power On
●Rotate among Setup items ：
MODE Button
●Setup parameters ：
SELECT Button
By pressing MODE and SELECT button at the same time after modification, the selected parameters will
be written to internal non-volatile memory then the change will be effective at next power on.
When you successfully change the parameter, you will see
POWER DOWN
PLEASE
！
Shutdown and power on or press SELECT button for 3 seconds.
If you power down before saving to memory the settings will be reverted to the way they were upon the
last save.
● Saving the change
：①
MODE
＋
SELECT Button (Save)
②
Shutdown and power on or Press SELECTButton 3 sec
● Cancel the change
：
Power off while doing change