BIONIME Rightest GT100, User Manual, Page: 10 / 30

17 16
Meter activation and Battery change
1. Turn the Meter over.
Press and push battery
cover to open.
CAUTION
- Please follow the local regulation and discard a used battery properly.
4. The RIGHTEST Blood Glucose Meter will perform a self test.
5. Press any button to exit the self-test and enter Setting Mode.
6. Set the time and date when the battery is replaced. See Chapter "Setting Up Your Meter - Setting
the Time, Volume and Date". Test results are still stored in the memory.
3. Slide the battery cover
back until it snaps into
place.
2. Install the battery. Be sure to
put battery in correct direction.
Meter activation and Battery change
Your RIGHTEST Blood Glucose Meter comes with 1 CR2032, 3 volt, battery installed. New battery will
provide power to perform about 1000 tests under normal use. Press the main button or insert a strip
to activate your meter.
NOTE
- After pressing the main button for 3 seconds, screen display will turn off. Keep pressing the
main button to enter the setting data.
- Continue to press the main button allows you to change settings. To return to the time
mode, quickly press the main button to reach the desired setting.
You can enter Setting Mode two ways.
1. Reload battery
After removing the battery, press the main button several times until there is no signal on screen,
then follow the battery installation steps to load batteries. RIGHTEST Blood Glucose Meter
performs a self test. Press the main button to exit the self test and enter Setting Mode.
2. With Battery inserted
Press the main button first to turn on RIGHTEST Blood Glucose Meter. Then press and hold the
main button for 7 seconds ( NOTE : Prior to the setting mode, the meter will turnoff) until you hear a
beep, indicating you have successfully entered Setting Mode. The display screen will show setting
data.