Bionet CardioCare 2000, Operation Manual

Page: 46 / 61

46 / 61
Ver. 2.41
CardioCare2000 Operation Manual
3) Monitor mode output
In monitor mode output, the measured ECGs is displayed in real-time.
This output function can be used for the purpose of checking out that the entire channel signal
is active before recording ECGs and monitoring ECGs of the patient for long time.
In this monitor mode, filter setting is fixed as follows ;
BASE LINE On
Muscle filter Off
AC Rejection Filter 60hz
Low Pass Filter 40hz
Printing speed can be set to 12.5 mm/s, 25mm/s, 50mm/s and signal level can be set to
5mm/mV, 10mm/mV, 20mm/mV, aut.
Output method
Filter setting value is fixed. Set the required printing speed and signal level and press MON
key. Then, the system starts printing according to the selected speed with the following
message on the LCD.
Press key or key to stop printing. Then system stops printing and displays system
setting after indicating following message for 1 second on the LCD.
Output form
In monitor mode output, 12 channel rhythms are printed simultaneously and continuously as
shown below.
Indicated heart rate is the average of previous 8 heart rates.
If the MONI M-CH is set at 3 or 6, please press key to start printing.
When you press key again the lead is changed to next group and the printing starts.
If you want to stop in the middle of printing, press the key.
* MONITOR *
Printing
* MONITOR *
aborted!