Bionet CardioCare 2000, Operation Manual

Page: 32 / 61

32 / 61
Ver. 2.41
CardioCare2000 Operation Manual
1) Introduction
1. Turn the power switch on after connecting leads to the patient according to preparation
for ECGs recording of Chap2.
2. Set the filter, signal level, display speed, channel form, rhythm lead according to
“Basic
Setting
” of Chapter3..
3. Enter the patient information according to
“Basic Setting –Enter Patient Data” of
Chapter 3.
4. Press the REC key to record patient ECGs after READY indicator lamp lights up
5. In case READY indicator lamp does not light up, press MONI key to check out
the ECG signal. If you are still troubled with poor signal, take necessary steps
according to
“Lead-off troubleshooting” of Chapter 2 .
6. Press COPY key to print the same report as previously printed one. Press
key to exit during printing or recording of ECGs.
For a convenient operation, memorize the short keys described below.
MONITOR : Displays real-time ECGs from the patient continuously or
monitoring the patient ECGs for long time,
RECORD : Records ECGs for 10 seconds by pressing key and prints in
A4 sized report form after calculating the measurement parameter of the
recorded ECGs
COPY: Prints the same report as previously printed one in record mode
or prints after changing system setting such as filter, signal level, output
speed, channel form, rhythm cannel of previously recorded ECGs data in
record mode
STOP: Exit during printing or recording of ECGs