Bio-Logic PURE WATER PACK BIO 1.5 PWP, Owner'S Manual

Page: 15 / 20

15
b
allast
n
o
. 10-0518a
and
10-0514a
haVe
l
amP
-
out
P
roteCtion
If power is applied to the ballast without a lamp connected to the circuit or if the lamp fails, the ballast’s lamp-out protection
will prevent the ballast from operating, and a red LED light will illuminate and audio alarm will sound. To reset: disconnect the
ballast from power and reconnect or replace the lamp. The ballast must remain disconnected from power for (2) minutes to
reset. After 2 minutes restore input power, ballast should resume proper operation.
The equipment that this ballast is used with requires connection to a known good ground. It is the User’s
responsibility to ensure that their equipment is properly grounded in compliance with the National Electrical Code and any
applicable local codes. Equipment wiring and hook up should be performed by a qualified, licensed electrician. Failure to comply
with this requirement could result in serious injury or death.
TECHNICAL SPECIFICATIONS
Table 3 - Technical Specifications
Model: Pure Water Pack
TM
Flow Rate (GPM): 1.5
Inlet\Outlet Size:
1/4” Tubing to 3/8” MNPT
John Guest
TM
Connector
Number of Lamps: 1
Lamp Model No.: 05-1366-R
Quartz Sleeve: Yes
Length: 14 1/2”
Width: 5 3 /4”
Height: 18”
Shipping Weight: 18 Lbs
Voltage:

120V 50/60Hz
Power Consumption:
k
14 Watts
Max Operating Pressure: 100 PSI
Ambient Room Temperature: 35° F - 100° F
Lamp Out Indicator Yes
Installation Kit Yes
Sediment Filter Cartridge Yes, 5 Micron
Carbon Filter Cartridge Yes
Chamber Material 316 Stainless Steel
M
220v 50/60Hz and 12v DC units are also available. Consult Factory for specific voltage requirements.
k
Wattage is lamp watts only, and does not include ballast loss.
All specifications, dimensional data, etc are approximate and subject to change without notice.
12 Volt and 24 Volt Direct Current (DC) Ballasts and Units
Many individuals regard ballasts and units powered by 12 volt and 24 volt Direct Current (DC) to be
relatively benign from a safety standpoint. However, a DC ballast, in order to operate an ultraviolet
discharge lamp, must produce an output as high as 600 volts. This voltage is high enough to produce a
very serious or even lethal electric shock. IT IS IMPERATIVE that all DC ballasts and DC ultraviolet
units be wired and grounded appropriately.