11
6. Clean the inside of the filter housing before installing the new filter cartridge. Wash the inside of the filter housing with soap
and hot water, rinse out thoroughly. Make sure the O-Ring is fully seated, in its groove.
7. Remove the wrapper from the new filter cartridge, and place into the filter housing. The filter cartridge will fit into the
filter housing in either direction. The system uses 2 different filter cartridges. Be sure to install the correct cartridge into its
corresponding filter housing.
8. Replace filter housing and cartridge onto filter head and firmly tighten, by turning filter housing counter-clockwise. Be careful
not to cross thread the housing and filter head.
9. Repeat to replace the second filter cartridge.
10. Lift the handle, of the system faucet, and lock the faucet in the “ON” position. Slowly open the supply valve, and allow the
system to fill with water.
11. When water begins to flow from the faucet, allow water to run for several minutes until it is clear with no air bubbles. Turn
off the faucet and check between the filter housing and head for leaks.
12. It is recommended, when installing a new carbon filter, to allow the water to run for 10 minutes to flush the filter and system
prior to use.
13. Restore power to the water purifier.
l
amP
i
nstallation
or
r
ePlaCement
bio-1.5
using
ballast
no
.10-0518a 120
V
50/60h
z
and
using
ballast
no
.10-0514a 230
V
50/60h
z
IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY
EQUIPMENT: SAFETY GOGGLES OR A FACE SHIELD, AS WELL AS GLOVES
Figure 7 - Lamp Replacement
1.
Disconnect power to water purifier, and remove ground connector from the chamber.
2. Remove
EASY-OFF
TM
End Cap by pulling cap off static gland nut.
3. Pull lamp cord and carefully withdraw lamp approximately 2 inches from chamber. While holding lamp
end, remove lamp socket from exposed lamp end.
4. Carefully withdraw lamp from chamber. Be sure to withdraw lamp straight out without angling
until completely clear of quartz sleeve.
Lamp and quartz sleeve are easily damaged. Exercise care when handling. (Continued on Page 12)
Step 1 - Disconnect Power to Water
Purifier and Remove Ground Connector
Step 4 - Remove Lamp
Step 3 - Remove Socket
Step 2 - Remove End-Cap
Summary of Contents for PURE WATER PACK BIO 1.5 PWP
Page 19: ...19 MAINTENANCE NOTES...
