Field
Description
•
)
(default value): RIP is not enabled.
•
A 9
: Enables sending and receiving of version 1 RIP
packets.
•
A 9
: Enables sending and receiving of version 2 RIP
packets.
•
A 9/9
:Enables sending and receiving RIP packets of
both version 1 and 2.
•
A 9 *##
: RIP V1 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
•
A 9 *##
: RIP V2 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
Route Announce
Select this option if you want to set the time at which any activ-
ated routing protocols (e.g. RIP) are to propagate the IP routes
defined for this interface.
Note: This setting does not affect the interface-specific RIP con-
figuration mentioned above.
Possible values:
•
.+ 5
(not for LAN interfaces, interfaces in Bridge
mode and interfaces for leased lines): Routes are propagated
if the interface status is up or ready.
•
.+ 1(
(default value): Routes are only propagated if the
interface status is up.
•
317(
: Routes are always propagated independently of op-
erational status.
12.1.2 RIP Filter
In this menu, you can specify exactly which routes are to be exported or imported.
You can use the following strategies for this:
• You explicitly deactivate the import or export of certain routes. The import or export of all
other routes that are not listed is still allowed.
• You explicitly activate the import or export of certain routes. In this case, you must also
explicitly deactivate the import or export of all other routes. This is achieved using a filter
for IP Address / Netmask = no entry (this corresponds to IP address 0.0.0.0 with net-
mask 0.0.0.0). To make sure this filter is used last, it must be placed at the lowest posi-
12 Routing Protocols
bintec elmeg GmbH
254
bintec RS Series
