Property
bintec RS232j
bintec RS232jw
bintec RS232j-4G
Online documenta-
tion
User's Guide
Workshops
MIB reference
User's Guide
Workshops
MIB reference
User's Guide
Workshops
MIB reference
3.4.7 Reset
If the configuration is incorrect or if your device cannot be accessed, you can reset the
device to the ex works standard settings using the Reset button on the back of the device.
All the existing data will be deleted if you do this.
Proceed as follows:
(1)
Switch off your device.
(2)
Press the Reset button on your device.
(3)
Keep the Reset button on your device pressed down and switch the device back on.
(4)
After the
LED has flashed five times, release the Reset button.
Note
If you delete the boot configuration via the GUI (menu Maintenance->Software
&Configuration) all passwords are also reset and the current boot configuration is de-
leted. The next time, the device will boot with the standard ex works settings.
You can now configure your device again as described from
on page 50
.
3.5 Cleaning
You can clean your device easily. Use a damp cloth or antistatic cloth. Do not use solvents.
Never use a dry cloth; the electrostatic charge could cause electronic faults. Make sure that
no moisture can enter the device and cause damage.
3.6 Pin Assignments
3.6.1 Serial interface
Your device has a serial interface for connection to a console. This supports Baud rates
from 1200 to 115200 Bps.
bintec elmeg GmbH
3 Installation
bintec RS Series
43
