Binder MKF 115, Operating Manual

Page: 19 / 115

MKF+ MKFT (E3.2) 07/2017 page 19/115
3. Completeness of delivery, transportation, storage, and installa-
tion
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the chamber and its optional accessories, if any, based on the delivery
receipt for completeness and for transportation damage. Inform the carrier immediately if transportation
damage has occurred.
The final tests of the manufacturer may have caused traces of the shelves on the inner surfaces. This has
no impact on the function and performance of the chamber.
Please remove any transportation protection devices and adhesives in/on the chamber and on the doors
and take out the operating manuals and accessory equipment.
Remove the upholstered transport piece (L-type profile)
from the lower door locking and keep it for possible later
transportation.
Figure 7:
Door locking with transport piece (state of delivery)
CAUTION
Sliding or tilting of the chamber .
Damage to the chamber .
Risk of injury by lifting heavy loads.
∅
Do NOT lift or transport the chamber using the door handle, the door or the lower
housing.
∅
Do NOT lift the chamber by hand.

Keep the chamber in upright position.

Lift the chamber from the pallet using technical devices (fork lifter). Set the fork lifter
only from the rear in the middle of the chamber. Make sure to place all the lateral sup-
ports of the chamber on the forks.
If you need to return the chamber, please use the original packing and observe the guidelines for safe
lifting and transportation (chap. 3.2).
For disposal of the transport packing, see chap. 18.1.
Note on second-hand units (Ex-Demo-Units)
Second-hand units are chambers that have been used for a short time for tests or exhibitions. They are
thoroughly tested before resale. BINDER ensures that the chamber is technically sound and will work
flawlessly.
Second-hand units are marked with a sticker on the chamber door. Please remove the sticker before
commissioning the chamber.