Binder KB 115 (E4), Operating Instructions Manual

Page: 46 / 149

KB (E4 + E6) 02/2017 page 46/148
9.3 Creating a new time program
For each program section you can enter a temperature set-point, the fan speed, the section’s duration,
the type of temperature transition “R” (ramp) or “S” (step) (see chap. 9.3.6), and the tolerance range.
When changing the temperature set-point, check the setting of the safety controller (chap.
17.2 and 17.3) if the safety controller has been set to “Limit” mode.
If the fan is operated with less than 100 % speed, the temperature performance and the spa-
tial exactitude of the temperature can differ from the manufacturer’s specifications. The fan
speed rate should only be reduced if absolutely necessary to meet special requirements.
Programming is saved in case of a power failure or after turning off the chamber.
To enter a new time program, go to Menu > Programs > Time programs > Create
Fixed value
08.03.2015 05:05:06
Submenu “Time program”.
Select “Create"
and press the operating button.
..\ Programs\Time programs
Start
Stop
Pause
Resume
Edit
Create
Rename
Delete
Close Home
Creating a new program
Fixed value
08.03.2015 05:05:06
Submenu “Create new program”.
Select “New", to create an entirely new program, or
“Based on…”, to use an existing program for further
editing
and press the operating button.
..\ Create new program
New
Based on…
Close Home