NAVIGATION
25
the Route Plan screen (see page 34).
Tap
to go back to the Search Menu screen.
Tap
to view the location on the map and once in the map view you can browse the
map (see page 19), to exit from the map view back to the previous screen tap
.
Tap
to delete the currently selected address book entry.
Warning: you will not be
asked to confirm the deletion, so make sure that you wish to carry out this operation before
tapping.
6.5 Selecting a Point on the Map
This option allows you to move around the map
and to select a location which you want to use as
your destination.
Tap Point On Map the screen will change to show
the map. The location of the map will either be your
current/last known GPS position or the last position
you viewed on the map.
You can then browse the map (see page 19) and
select a point you want to navigate to by placing
the cursor.
After placing the cursor at a point on the map, it may contain further information, i.e. if
there is more than one POI at that point. In this case you can use the
arrows to scroll between the multiple points.
Tap
to go back to the Search Menu screen.
Tap
to confirm the point. The screen will then change to show the Route Plan
screen (see page 35).
6.6 Entering a set of
Co-ordinates
This option allows you to enter the longitude and
latitude co-ordinates of the location you are looking
for. Tap Coordinates the screen will change to the
co-ordinates entry screen.
You can enter the co-ordinates in two different ways,
Degrees:minutes:seconds or as a Decimal, the unit
automatically defaults to the
Degrees:minutes:seconds format (Note: when the
unit displays the co-ordinates of a location it always
shows then in the Degress:minutes:seconds format).
Tap in the white boxes next to either Lon or Lat, then
use the keyboard to enter the co-ordinates you wish to
navigate to.
When entering in Degrees:minutes:seconds format. For
Longitude the letters E and W are used to describe the
hemisphere, for Latitude the letters N and S are used to
indicate the hemisphere. ° is used to indicate the
degrees and ‘ is used to indicate the minutes.
