Operating manual No.
057-2-6-0010-R0
Page 18
Version 2021
EN
5
Installation section
The machine must be installed in compliance with the safety regulations and instructions included
in this chapter.
Simple precautions are necessary for the positioning of the press.
Always consider the safety aspect not only in relation to the work performed with the press but also
to the hazards caused by other machines present in the workplace.
Before positioning the machine make sure that:
The flooring is suitable for placing the press, i.e. without holes, yielding parts, and its
capacity is sufficient to support the weight of the press plus the weight of the accessory parts
and any large work piece, considering an adequate safety factor. CAPACITY
If the positioning must be performed on lofts, upper floors or elevated areas, make sure that
the maximum capacity of the lofts or flooring is higher than the weight of the press and any
accessory weights, considering also an adequate safety factor.
Do not place the machine on yielding or non-compact surfaces (e.g. on gravel or crushed
stone, sand, etc.).
PAY CLOSE ATTENTION TO THE OVERHEAD POWER LINES.
Check in advance the position of any overhead power line and signal them with appropriate
warning signs.
Always consider an adequate distance from the sliding ways of the means of transport,
elevators, pallet jacks, etc. Sources of unpredictable and sudden hazard.
Make sure that the identified position is always equipped with adequate lifting systems.
Pay the utmost attention to the handling of lifting systems (e.g. gantry cranes, hoists, pallet
jacks, forklift trucks, cranes, jib cranes, etc.)
Fasten the press to the ground through the appropriate holes located on the feet of the
machine. Use dowels with M12 screws to anchor the machine.
