•
Place the brush on the pulley;
•
Fasten the brush to the pulley by tightening the three
screws.
•
Put the machine back on the horizontal;
•
It now requires filling with fuel;
•
Open the seat cowling until the support rods lock into
place;
•
Unscrew the fuel tank cap;
•
Fill with fuel, close the tank and lower the seat cowling;
•
If not ordered at the moment of purchase, the 12V 20 Ah
starting motor battery must be mounted.
•
Remove the black guard between the levers at the base
of the handlebar;
•
Position the battery in the battery compartment and
connect the cables to the terminals (RED positive -
BLUE negative).
The electric model requires additional operations depending on the
order:
If the batteries were ordered together with the machine,
they will already be mounted and checked by the
Manufacturer and before use the side brushes must be
mounted as described above;
IMPORTANT - Do not tilt the machine with the
batteries mounted: remove the batteries before
tilting the machine.
If this is not the case, the customer must obtain 2 x 12 V
140 Ah batteries (with relevant 24V and 10A battery
charger) and perform the following operations.
IMPORTANT - Do not use battery chargers with
different powers to charge the batteries
•
Open the seat cowling;
•
Place the batteries on the brackets;
•
Fix the batteries in position by tightening the wing nut on
the threaded vertical bar;
•
Connect the batteries in series as shown below (the
positive and negative terminals are differently shaped
and cannot therefore be reversed);
•
Verify the level of electrolyte inside the elements;
•
Leave the cowling open while charging is underway to
ensure adequate ventilation of the battery compartment;
•
Charge the batteries by plugging the battery charger
connector into the socket on the left of the machine;
BLUE
negative
RED
positive
connecting cable
BLUE
negative
RED
positive
machine cables
tank cap
BLUE (-)
negative
RED (+)
positive
screws
cowling
support rod
battery
